Panel Mount USB Cable - USB A Plug to USB A Right Angle Socket - 30cm
Qty | Discount |
---|---|
1-9 | $3.95 |
10-99 | $3.56 |
100+ | $3.16 |
Description
This handy USB extension cable will make it easy to enclose a device with an A-type (USB host) port. We think this would be most handy when putting a Beagle Bone, Raspberry Pi, or Mintyboost into a box.
The jack half has two mounting 'ears' with 8mm M3 screws installed, 30mm apart. The ears are flexible, so the holes don't have to be drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 13.2" long from tip to tip (with 9.4" cabling between USB connectors).
Technical Details
- Panel mount USB type A socket with USB type A plug at cable end
- 28 AWG data, 24 AWG power wires
- Shielded with wire braid
Dimensions:
- 13.2" / 335mm long from tip to tip
- 9.4" / 240mm cable length between connectors
- 2 x 8mm M3 mounting screws, ~30mm apart
- Weight: 26.3g
-
Core Electronics
Australia -
Electrokit Sweden AB
Sweden -
The Pi Hut
United Kingdom -
Makersify
United Kingdom -
DigiKey Electronics
United States
See our Distributors page for a complete list of distributors.